Water is everywhere in Terraria, and you can use it with almost everything – from creating Potions and synthesizing Dyes to fishing and crafting. However, they may be out of reach (if you’re unlucky), especially if you need them in Master mode.
In this guide, we’ll help you get infinite water in Terraria. We present three different ways so you’ll never run out of sources!
Note: Follow our step-by-step guide properly to get the results you want.
1. Glitch
1.1 Get a full Water Bucket.
1.2 Build a pool or a pit using any blocks of any size.
1.3 Create a T-shaped platform out of four blocks
1.4 Remove the center block of the T-shaped platform to form a V shape.
1.5 Stand on the edge of the V.
1.6 Put the cursor on the left edge of the V-shaped block, and make sure the water bucket in the inventory is selected.
1.7 Click and hold the Use/Attack Button.
1.8 If everything is set up correctly, water should fall.
2. Bottomless Water Bucket
2.1 Obtain a Bottomless Water Bucket.
2.2 Make a pool or a pit of any size.
2.3 Click and hold the Use/Attack Button.
3. Using Pumps
3.1 Create and build a container, a pit, or a pool using any blocks of any size.
3.2 Craft one Inlet Pump and one Outlet Pump, Switch, Wires, Wrench, and Wire Cutter.
3.3 Place the Inlet Pump in the nearby bodies of water.
3.4 Place the Outlet Pump in the newly created pit/container so that the outgoing liquid falls into it.
3.5 Place the switch near the Outlet Pump.
3.6 Connect the Outlet Pump, Inlet Pump, Switch, and Wires, using the Wrench.
3.7 Press the switch to start pumping water into the container.
